Usually, routers provide more functionality as compared to access points e.g. In the above image, you can see the 3 different devices are connected to the access point however they are not yet assigned the IP address. To connect the Laptop or PC, we have to remove the Ethernet module and add the wireless module so these devices can support wireless connectivity while the other two devices have the wireless module preconfigured. We can configure port 1 of the access point for the wireless-related settings.īy default, SSID is configured as default and authentication is disabled and the same is configured on end devices available so we just have to add the devices to the map and they will connect to the access point immediately because the devices are preconfigured with the required settings however If we have changed the SSID and enabled the authentication then we have to connect the device with the available SSID and also for authentication, the password must be entered. In this lab, we will configure a wireless access point in the Cisco packet tracer, and devices like phones, tabs, and laptops will be connected to the network.Ī wireless access point allows devices to connect to the network wirelessly so to connect different devices to the access point, we have to configure the access point for basic settings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |